Part Number 8153922, Sammys® 3/8" Vertical Threaded Rod Anchor - XP 35
Two step installation process
No custom bracket assembly required
Reduces installation time and cost
Threaded rod attachment
Allows specifiers and designers to engineer systems with fewer attachment points
Holds from 1146-1783 lbs.
Installs with SAMMY X-PRESS IT installation tool
Ensures correct installation torque
Reduces occurrences of fastener failure due to over driving
INSTALLATION INSTRUCTIONS
Installation Notes
1. Insert the bit receiver with 25/64” drill bit into the chuck of a minimum 18-volt battery operated drill and drill the 25/64” hole through the metal deck at the desired location.
2. Slide the sleeve of the A88X-Press It® over the drill bit until it connects to the receiver.
3. With the internally-threaded portion of the anchor (XP 20, XP 35) positioned inside the socket of the installation tool, secure the square base of the Sammy X-Press® within the square recessed guidelines of the installation tool.
4. Insert the Sammy X-Press® anchor through the pre-drilled hole. Install the Sammy X-Press® anchor to release the expandable portion of the anchor and secure the anchor in the metal deck or purlin to allow vertical orientation of threaded rod.
Important Note: Warranty requires the use of the appropriate Sammy X-Press It® Tool for installations.
STRUCTURAL CONCRETE OVER METAL DECK (Follow steps 1-4 before pouring concrete)
NON-STRUCTURAL LIGHTWEIGHT CONCRETE APPLIED OVER METAL DECK NOT FOR USE WITH AIR DRY DENSITY GREATER THAN 35 PCF (Follow steps 1-4 before the LWC has been applied).
