All Categories > Screws > Self-Drilling Screws > Wood-to-Metal Self-Drilling Screws > Teks® 4 WTM with Wings Wood-to-Metal Self-Drilling Screws > Part Number 1552500  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Part Number 1552500, Teks® with Wings Wood-to-Metal Self-Drilling Screws - TEKS® 4 3PFH W/WINGS SPEX™ 12-24 X 1-5/8"


  • Teks Drill Point
    • Non-walking, cutting edges, pigtail reduction
    • Engages material faster, drills with less effort, safer installation
  • Cutting wings
    • Ream a hole in fastened wood
    • Prevents thread engagement in fastened wood while drilling
  • Choice of Phillips Wafer head, Flat head, Square Driv flat head
    • Allows installer a choice of drivers
    • No need to switch drives, saves time
  • Gray Climaseal™ Coating
    • Provides excellent corrosion resistance
    • Lasts longer




 SPECIFICATIONS   APPLICATION   PRODUCT FEATURES   INSTALLATION GUIDELINES   

A standard screwgun with a depth sensitive nosepiece should be used to install Teks. For optimal fastener performance, the screwgun should be a minimum of 6 amps and have an RPM range of 0-2500.

Adjust the screwgun nosepiece to properly seat the fastener.

Worn or damaged bit tip should be replaced.

The fastener is fully seated when the head is flush with the work surface.

Overdriving may result in torsional failure of the fastener or stripout of the substrate.

The fastener must penetrate beyond the metal structure a minimum of 3 pitches of thread.

All 1/4 and #12 diameter "Winged" parts must be driven into a minimum of 1/8" steel in order to break the wings consistently.


 DOWNLOADS 

2019 Buildex Brochure for Teks® 3 WTM and 4 WTM Wood-to-Metal Self-Drilling Screws
(PDF, 160KB)

Teks 4, 4.5, & 5 DWG

Teks 4, 4.5, & 5 DXF

Teks 4, 4.5, & 5 IGS