All Categories > Anchors > Hollow Wall Anchors > E-Z Products Hollow Wall and Wallboard Anchors > Part Number 5014901  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Part Number 5014901, E-Z TOGGLE®


  • Toggle anchor
    • Delivers 70-150lbs. Load capacity
    • Attach heavier loads to dry wall
  • EZ Ancor Drill Point
    • Predrills precise hole in gypsum wall board
    • No hole preparation required
  • Quick one tool installation
    • Only requires a Phillips screw driver
    • Saves time




 SPECIFICATIONS   PRODUCT SPECIFICATIONS   APPLICATIONS   PRODUCT FEATURES   INSTALLATION GUIDELINES   

AREA BEHIND WALL MUST ALLOW TOGGLE TO OPEN FREELY

1. Using a #2 Phillips screwdriver, drill the E-Z Toggle Anchor into drywall until the head of the anchor is seated flush.

2. To “set” the clamp behind the drywall, place the mounting screw into the anchor and push or tap firmly until approximately 1" of screw is protruding (do not rotate). Then remove the screw.

3. Place fixture over E-Z Toggle, insert screw and continue to turn until fastened tightly (for example, when attaching a 1/2" thick fixture, it will require approx. 23 full rotations of the screwdriver to fully tighten the fixture).


 DOWNLOADS 

2019 Buildex Brochure for E-Z Products Hollow Wall and Wallboard Anchors
(PDF, 187KB)